SETTING UP + INSTALLATION
Fig. 2
1
2 
3
Remove the polystyrene base and place the machine near its permanent position (diagram 1).
Carefully cut through the hose retaining clip at the rear of the appliance (diagram 2).
Unscrew the central bolt (A); unscrew the 4 lateral screws
(B) and remove the cross piece (C) (diagram 3).
Lean the machine forward and remove the plastic bags containing the two polystyrene blocks at the sides, pulling downwards (diagram 4).
Press the plug (to be found in the envelope with the instructions) into the hole and rotate to lock into position (diagram 5).
Technical data
■Max. load of dry laundry
■Water pressure
Measurements
■Width
■Depth
■Height
5 kg
0,05 ÷ 0,8 MPa
60 cm
52 cm
85 cm
WARNING:
DO NOT LEAVE THE PACKAGING WITHIN REACH OF CHILDREN AS IT IS A POTENTIAL SOURCE OF DANGER.
NB: For specifications regarding electrical data, see the data panel on the front of the washing machine (porthole area) - as shown in diagram above.
EC Appliance complies with European Directive 89/336/EEC, 73/23/EEC and subsequent amendments.
26
Apply the insulation sheet of corrugated material to the base as shown.
Level the machine by means of the front feet. |
|
a) Turn the nut clockwise to release the screw adjuster on the foot. | A |
b) Rotate the foot to raise or lower it until it stands firmly on the |
|
ground. | B |
c) Lock the foot in position by turning the nut | |
|
C
27