40000755.qxd 30/10/2003 15:04 Page 7
Installation & testing
Note: when lifting the machine always use two people to avoid injuries.
Remove the machine from the packaging – close to where it will finally be positioned remembering the plug must be easily accessible after installation – and proceed as follows:
On the back of the machine
1) Remove the central screw A and side screws B and pull out the transit bracket C along with the red locator.
2) Tilt the machine forward and remove the two polystyrene spacers.
3) Cover the central hole using the cap
enclosed in the instructions bag.
4)Adjust the two feet at the front to level the machine.
5)Tilt the machine forward and locatethe base
panel by (1) removing the paper backing from the adhesive tape,(2) locate the base panel in the front of the machine, (3) offer the base panel up to the base of the washing machine and locate the two push clips.
7
