Carrying handle
The deep cleaner may also be lifted by placing a hand above the upper clean solution tank handle as shown.
B |
Automatic shut off
When the recovery tank (lower tank) is full the automatic shutoff mechanism will shut off the deep cleaner suction (suction will be noticeably reduced).
At that time, the yellow float disk will rise to the top of the recovery tank lid (B). The deep cleaner will no longer pick up dirty solution and the motor sound will become noticeably higher in pitch.
When this happens, turn deep cleaner off and empty recovery tank before continuing use.
Check clean water tank also; it may need to be refilled.
Do not use without float and float retainer in place. If broken or dis- lodged, take to an Authorized Hoover Service Center or Dealer for repair.
Brush setting selector
Your ‘SteamVac’ deep cleaner has two agitator brush settings.
ON - for cleaning of carpet and bare floors
OFF - for cleaning carpets and bare floors when brushing is not desired.
Slide selector button to the desired set- ting before cleaning.
F | H |
OF | |
| WAS |
ON | nseiR |
Wash/rinse switch
This switch allows you to easily change from cleaning your carpet or floor with a detergent/water mix to rinsing with water only.
Set the switch to WASH to clean the car- pet or floor with detergent and water.
Set the switch to RINSE to use water only.
See “How to clean” section for more details.
C |
D |
The tanks
Clean water tank
(upper tank)
The clean water tank (C) holds the water that will either be mixed with detergent for cleaning the carpet or floor, or used to rinse the carpet or floor.
The detergent container (D) is perma- nently attached to the water tank. It holds the detergent that mixes with the water.
How to fill
Unplug deep cleaner from electrical outlet.
Place deep cleaner handle in the upright, locked position.
To remove tank, press down on tank handle and pull forward.
8
