SETTING UP + INSTALLATION
| Fig. 2 |
|
|
Technical data |
|
|
|
■ Max. load of dry laundry for washing | 6 kg |
■ Max. load of dry laundry for drying | 4 kg |
■ Water pressure | 0,05 ÷ 0,8 MPa |
Measurements |
|
1
2 
3
D
Remove the polystyrene base and place the machine near its permanent position (diagram 1).
Carefully cut through the hose retaining clip at the rear of the appliance (diagram 2).
Unscrew the central bolt (A); unscrew the 4 lateral screws
(B)and remove the cross piece (C).Unscrew the two rods D and remove them. Two plastic spacers will fall inside the machine. (diagram 3).
Lean the machine forward, remove the mentioned plastic spacers and remove the plastic bags containing the two polystyrene blocks at the sides, pulling downwards. (diagram 4).
Stop the holes using the plugs that you will find inside the bag containing the instruction booklet. (diagram 5).
4 |
| 5 |
|
|
|
■ Width | 60 cm |
■ Depth | 54 cm |
■ Height | 82 cm |
NB: For specifications regarding electrical data, see the data panel on the front of the washing machine (porthole area) - as shown in diagram above.
EC Appliance complies with European Directive 89/336/EEC, 73/23/EEC and subsequent amendments.
WARNING:
DO NOT LEAVE THE PACKAGING WITHIN REACH
OF CHILDREN AS IT IS A POTENTIAL
SOURCE OF DANGER.
Apply the insulation sheet of corrugated material to the base as shown.
Level the machine using the 4 feet. | A |
a) Turn the nut clockwise to release the screw adjuster on the foot. | |
b) Rotate the foot to raise or lower it until it stands firmly on the |
|
ground. | B |
c) Lock the foot in position by turning the nut | |
|
C
32 | 33 |