Horizon Fitness GS 1035T manual S E M B Ly, Unpacking, Tools Included, Parts Included

INTRODUCTION IMPORTANT

PRECAUTIONS

ASSEMBLY

BEFORE

YOU BEGIN

TREADMILL

OPERATION

CONDITIONING TROUBLESHOOTING LIMITED

GUIDELINES & MAINTENANCE WARRANTY

6

A S S E M B LY

IMPORTANT: READ THESE SAFETY INSTRUCTIONS BEFORE USE!

WARNING

During the assembly process of the treadmill there are several areas that special attention must be paid. It is very important to follow the assembly instructions correctly and to make sure all parts are firmly tightened. If the assembly instructions are not followed correctly, the treadmill could have frame parts that are not tightened and will seem loose and may cause irritating noises. There should be no side-to-side play in the console masts or any forward and back play in the console assembly or handlebars. If there is any play in these areas, the treadmill has not been properly assembled. To prevent damage to the treadmill, the assembly instructions must be reviewed and corrective actions should be taken.

UNPACKING

Place the treadmill carton on a level flat surface. It is recommended that you place a protective covering on your floor. Take CAUTION when handling and transporting this unit. Never open box when it is on its side. Once the banding straps have been removed, do not lift or transport this unit unless it is fully assembled and in the upright folded position, with the lock latch secure. Unpack the unit where it will be used. The enclosed treadmill is equipped with high-pressure shocks and may spring open if mishandled. Never grab hold of any portion of the incline frame and attempt to lift or move the treadmill. FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN INJURY!

Before proceeding, find your treadmill’s serial number and model name located under the deck on the frame crossbar and enter it in the space provided below.

Enter your serial number and model name in the boxes below:

SERIAL NUMBER:

MODEL NAME:

*Refer to the serial number and model name when calling for service.

*Also enter this serial number on your Warranty Card.

READING RACK SPEAKERS

	WATER BOTTLE HOLDER
	CONSOLE
REMOVABLE CD / MP3 STORAGE	FAN
SUPPORT BAR	SAFETY KEY PLACEMENT
GRIP PULSE HANDRAILS
HANDLEBAR	CONSOLE MAST
ON/OFF SWITCH	MOTOR COVER
CIRCUIT BREAKER
	FOOT LOCK LATCH
POWER CORD
	RUNNING BELT / RUNNING DECK
	SIDE RAIL
TRANSPORT WHEEL
	ROLLER END CAP
ADR2™ CUSHIONING
	REAR ROLLER
	ADJUSTMENT BOLTS

TOOLS INCLUDED

c 4 mm L-wrench	c 10 mm L-wrench
c 5 mm T-wrench	c 17mm Flat Wrench

c6 mm T-wrench

(Used to adjust the rear roller adjustment bolts.)

PARTS INCLUDED

c 1	Console Assembly	c 1		Bottle of Silicone Lubricant
(located under treadmill deck)		c	1	Power Cord
c 2	Console Masts
		c	1	Audio Adaptor Cable
c 1	Support Bar
		c	1	Safety Key

c2 Handlebars

c5 Hardware Bags

If you have questions or if there are any missing parts, contact Customer Tech Support.

Contact information is located on the back panel of this manual.

For a complete exploded diagram, visit us at www.horizonfitness.com

7

IMPORTANT PRECAUTIONS INTRODUCTION

ASSEMBLY

BEFORE YOU BEGIN

TREADMILL OPERATION

LIMITED TROUBLESHOOTING CONDITIONING WARRANTY & MAINTENANCE GUIDELINES

GS_1035T_Treadmill_Rev.2.3.indd 6-7 6/13/07 11:17:33 AM