Hotpoint AQM8D 69 I instruction manual Description of the machine

Description of the machine

EN

PORTHOLE DOOR

PORTHOLE DOOR

HANDLE

KICK STRIP

ADJUSTABLE FEET

PORTHOLE DOOR

Always use the handle to open the porthole door (see figure).

DETERGENT DISPENSER DRAWER

The detergent dispenser drawer is located inside the machine and can be accessed by opening the door.

For more information on detergent measures, please refer to the chapter entitled “Detergents and laundry”.

CONTROL

PANEL

washing additives compartment: for fabric softener

or liquid additives. We recommend that the maximum level indicated by the grille is not exceeded, and that concentrated fabric softeners are diluted.

TOUCH CONTROL PANEL

To adjust the settings, gently press the icon inside the sensitive (touch control) area as illustrated in the figure.

Standby mode

This washer-dryer, in compliance with new energy saving regulations, is fitted with an automatic standby system which is enabled after about 30 minutes if no activity is detected. Press the ON-OFF button briefly and wait for the machine to start up again.

CHANGE LANGUAGE

The first time the machine is switched on, the first language will flash on the display. The ““, “OK” and “V” symbols will appear on the display, in line with the 3 buttons on the right- hand side. The languages change automatically every 3”; alternatively, they can be changed by pressing the buttons next to the ““ and “V” symbols. Use the “OK” button to

1

2

1.pre-wash compartment: use powder detergent.

2.main wash compartment: use powder or liquid detergent. If using the latter type of detergent, we recommend it is poured into the drawer immediately before you start the washer-dryer.

confirm the language, which will be set after 2”. If no buttons are pressed, the automatic language change will begin again after 30”.

The language may only be changed while the machine is switched off.

Press and hold the temperature +spin +delayed start buttons for 5’’; a short beep sounds and the set language flashes on the display. Press the buttons next to the ““ and “V” symbols to change the language. Use the button next to the “OK” symbol to confirm the language, which will be set after 2”. If no buttons are pressed, the language set previously will be displayed after 30”. Switch on the machine.

6