Hotpoint ARXXL105 manual The first wash cycle, Technical data

Models: ARXXL105

1 60
Download 60 pages 13.84 Kb
Page 3
Image 3
The first wash cycle

Connecting the drain hose

￿Do not use extension cords or multiple sockets.

GB

65 - 100 cm

Connect the drain hose, without bending it, to a drainage duct or a wall drain located at a height between 65 and 100 cm from the floor;

￿The cable should not be bent or compressed.

￿The power supply cable must only be replaced by authorised technicians.

Warning! The company shall not be held responsible in the event that these regulations are not respected.

The first wash cycle

alternatively, rest it on the side of a washbasin or bathtub, fastening the duct supplied to the tap (see figure). The free end of the hose should not be underwater.

￿We advise against the use of hose extensions; if it is absolutely necessary, the extension must have the same diameter as the original hose and must not exceed 150 cm in length.

Electrical connections

Before plugging the appliance into the electricity socket, make sure that:

the socket is earthed and complies with all applicable laws;

the socket is able to withstand the maximum power load of the appliance as indicated in the Technical data table (see opposite);

the power supply voltage falls within the values indicated in the Technical data table (see opposite);

the socket is compatible with the plug of the washing machine. If this is not the case, replace the socket or the plug.

￿The washing machine must not be installed outdoors, even in covered areas. It is extremely dangerous to leave the appliance exposed to rain, storms and other weather conditions.

￿When the washing machine has been installed, the electricity socket must be within easy reach.

Once the appliance has been installed, and before you use it for the first time, run a wash cycle with detergent and no laundry, using the wash cycle 1.

Technical data

Model

ARXXL 105

 

 

 

 

 

 

 

width 59.5 cm

Dimensions

height 85 cm

 

 

 

depth 56,5 cm

 

 

 

 

Capacity

from 1 to 7 kg

 

 

 

 

Electrical

please refer to the technical data

connections

plate fixed to the machine

 

 

 

 

 

 

 

maximum pressure 1 MPa (10 bar)

Water connections

minimum pressure 0.05 MPa (0.5 bar)

 

 

 

drum capacity 52 litres

 

 

 

 

Spin speed

up to 1000 rotations per minute

 

 

 

 

Energy rated

 

programmes

programme 6; temperature 60°C;

according to

using a load of 7 kg.

regulation

 

EN 60456

 

 

 

 

 

 

 

 

This appliance conforms to the

 

 

 

following EC Directives:

 

 

 

- 72/23/EEC dated 19/02/73 (Low

 

 

 

Voltage) and subsequent modifications

 

 

 

- 89/336/EEC dated 03/05/89

 

 

 

(Electromagnetic Compatibility) and

 

 

 

subsequent modifications

 

 

 

- 2002/96/EC

 

 

 

 

 

 

3

Page 3
Image 3
Hotpoint ARXXL105 manual The first wash cycle, Technical data