D ISHWASHER
How to use your Dishwasher
First of all.
-Turn on the water supply tap completely.
-Add the correct amount of detergent.
-Load the baskets correctly.
-Check that the spray arms rotate freely.
-Close the door securely.
-Press the
Select the wash cycle. Select the wash cycle by pressing button "P". Each time this button is pressed, one of the indicator lights “M”willcomeoninsequence.Select thewashcyclemostsuitableforthe type of dishes to wash (see ‘Pro- gramme Chart’).
Close the door and after a few sec- onds,youwillhearashortbeep:the wash cycle has started.
Modifying a wash cycle in progress.
Ifyouhavechosenthewrongcycle
-You can modify the wash cycle in progress, if it has only just started. Open the door carefully, to avoid anyhotwatersplashes.Thenkeep button "P" pressed in fro approxi- mately 5 seconds, until you hear 3 short beeps.
Indicatorlight"M"willgoouttoshow all the settings will have been can- celled. You are now free to
You've left out a dish? Interruptthewashcyclebyopening the door, carefully, then insert the dish you had forgotten.
When you shut the door the cycle will start up from where you inter- ruptedit.
Cycle end
The end of the wash cycle is indi- cated by 2 short beeps and the flashing of the wash cycle indicator light“M”.
Open the dishwasher door.
Turn the appliance off by pressing
Turn off the water tap.
Wait a few minutes before unload- ing the dishes: they are very hot! If youwaitalittlewhile,theydrybetter due to the steam.
Empty the lower basket first.
There's been a power failure or you opened the dishwasher door
The wash cycle stops and then restarts when the electricity comes backonorwhenyouclosethedoor.
7
