D ISHWASHER
How to use your Dishwasher
First of all.
-Turn on the water supply tap completely.
-Add the correct amount of detergent.
-Load the baskets correctly.
-Check that the spray arms rotate freely.
-Close the door securely.
-Press the
Select the wash cycle.
To select the wash cycle, turn knob "D" clockwise until the indicator on theknoblinesupwiththenumberor symbol for the wash cycle most suitable for the type of dishes to wash (see ‘Programme Chart’).
After a few seconds, you will hear a short beep: the wash cycle has started, it is not advisable to make any changes from this point.
Indicatorlights
Yourdishwasherisfittedwithindi- catorlights(E)thatcomeontoshow youatwhichpointthewashcycleis at.
Herearethesymbolscorrespond- ingtoeachcyclephase:
Starting from the indicator light on theleftmovingtowardstheoneon the right:
At all times, your dishwasher tells youwhereitisat.
Modifying a wash cycle in progress.
Ifyouhavechosenthewrongcycle
-You can modify the wash cycle in progress, if it has only just started. Turn knob "D"
You've left out a dish? Interrupt the wash cycle by press- ing the
The cycle will start up from where you interrupted it.
Cycle end
The end of the wash cycle is indi- cated by 2 short beeps and a flash- ing drying phase indicator light .
Set the knob to the reset position to clear all settings.
Turn the appliance off by pressing button “A”, cutting off the electricity supply.
Turn off the water tap.
Wait a few minutes before unload- ing the dishes: they are very hot! If youwaitalittlewhile,theydrybetter due to the steam.
Empty the lower basket first.
There's been a power failure or you opened the dishwasher door
The wash cycle stops and then restarts when the electricity comes backonorwhenyouclosethedoor.
7