Electrical Connection
Electrical Connection
THIS APPLIANCE MUST BE EARTHED.
The installation procedure must be carried out by a qualified electrician.
The electrical safety of this appliance is guaranteed only if the appliance is correctly earthed in compliance with the standards of electrical safety.
The manufacturer can under no circumstances be considered responsible for any damage that might occur due to incorrect earthing of the hob.
The electric hob is not supplied with a power supply cord because the type of cord used depends on the type of electrical connection (see following diagram). Open the terminal box, following the instructions illustrated in the diagram below:
IMPORTANT POINTS:
Your hob is supplied with a special connection cable.
If ever the cable is damaged it should be replaced by an authorised service engineer only.
Disconnect the hob form the electrical supply before any work is carried out.
Electrical Connections:
Connecting the supply cord to the electrical mains: The hob must be connected to the mains by a double pole mains switch, which must have a minimum 0f 3mm space between the contacts, correctly fused with a capacity appropriate to that shown on the hob Rating Plate. All electrical wiring from the consumer unit to the appliance, via the switched double pole cooker outlet, must be of an acceptable type and current rating as above.
The supply cord should conform to BS6004 conductor size 4mm2, must be positioned so that no part of it reaches a temperature of 50°C above room temperature. The electrical installation must comply with the IEE Regulations, Building Regulation & local
Before making the connection, make sure that:
•the limiter switch (fuse) and the residual wiring can support the appliance load (see the rating plate).
•the mains system is properly earthed in compliance with current regulations and provisions.
•there is easy access to the socket or the double pole switch after the appliance is installed.
IMPORTANT:
If the hob is installed above a
Supply cable installation
The electric hobs are supplied without a cable. Use a cable: 4mm2
•open the teminal box by removing the "V" screw and taking off the cover.
•Fix the cable in place with the "F" cable clamp, close the lid and fasten it with the "V" screw.
1 | 2 | 3 | 4 | 5 |
| ||
• | • | • | • |
|
| • | • |
|
| ||||||
| L |
|
|
| N |
|
Voltage and frequency of power supply:
7000W
V |
1 | 2 | 3 | 4 | 5 |
|
|
|
| F |
9