Door Reversal
You will need a cross head screwdriver, a flat blade screwdriver and a 5mm spanner to carry out this procedure.
Our Service Department can arrange for an Engineer to do the conversion for you but a charge will be made.
WARNING: Switch off electrical supply and pull out the mains plug.
Remove all loose fittings from inside the freezer.
If you have previously set up and used the freezer and since decided to reverse the doors, you must remove stored food, wrap or cover it and place into insulated containers to keep frozen whilst carrying out this operation.
1.Open the door as wide as possible.
Note : You may require assistance to do this:
2.Support the door and using a screwdriver, remove the screw securing the top hinge.
3.Lower the top hinge and carefully tilt the door to remove the hinge from the cabinet. Lift the door off the bottom hinge.
4.Remove the top hinge from the door.
5.Remove the spacing washers from the right hand bottom hinge pin.
6.Use a flat blade screwdriver or a 5mm spanner, to unscrew and remove the bottom hinge pin.
7.Unscrew the fixing screw to remove the right hand hinge cover plate.
(if applicable) Remove the door stop washer, if fitted to your model.
8. Replace the right hand |
| 9. Take the plastic cap |
cover plate with its |
| from the left hand |
original screw. |
| cover plate and use it |
|
| to fill the hole on the |
|
| right hand cover plate. |
|
|
|
10.Unscrew the fixing screw to remove the left hand hinge cover plate.
11.(if applicable) Put the door stop washer in position on the left hand hinge bracket, if fitted to your model.
Screw in the hinge pin.
12.Replace the left hand cover plate with its original screw.
Place the spacing washers onto the left hand bottom hinge pin.
14
