RECOMMENDATIONS AND SUGGESTIONS

Using your new Cooker Hood is very simple. Nevertheless, to get the best results it is important that you read this manual thoroughly before installing and using your appliance for the first time.

INSTALLATION

All installation and repairs should be carried out by a qualified technician in accordance to regulations in force.

The manufacturer will not be held liable for any damage resulting from incorrect or improper installation.

After having removed the packaging, check the condition of the appliance, if in any doubt, do not use and contact Hotpoint Service (see Key Contacts, back page).

The minimum safety distance between the hob and the extractor hood is 600 mm.

Check that the mains voltage corresponds to that indicated on the rating plate fixed to the inside of the hood.

For Class I appliances, check that the domestic power supply guarantees adequate earthing.

Connect the extractor to the exhaust flue through a pipe of minimum diameter 120 mm. The route of the flue must be as short as possible.

Do not connect the extractor hood to exhaust ducts carrying combustion fumes (boilers, fireplaces, etc.).

If the extractor is used in conjunction with non-electrical appliances (e.g. gas burning appliances), a sufficient degree of ventilation must be guaranteed in the room in order to prevent the backflow of exhaust gas. The kitchen must have a suitable vent to the outside of the building, so that clear fresh air can circulate through the kitchen.

USE

600mm min.

The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells.

Never use the hood for purposes other than for which it has ben designed.

Never leave high naked flames under the hood when it is in operation.

Adjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not engulf the sides.

Deep fat fryers must be continuously monitored during use: overheated oil can burst into flames.

When frying, never leave the pan unattended.

The hood should not be used by children or persons not instructed in its correct use.

MAINTENANCE

Switch off and unplug the appliance from the mains supply before carrying out any cleaning or maintenance work.

Clean regularly (see Care and Cleaning section), build up of dirt and grease could cause a fire hazard.

GB

 

3

Page 3
Image 3
Hotpoint HT9X manual Recommendations and Suggestions, 600mm min