Hotpoint HUG 52X, HUG 52P, HUG 52K Hotplates, Gas Cut Off, Safety Requirements for Deep FAT Frying

Hotplates

Gas Cut Off

This cooker has a safety cut out feature which switches off the burners when you close the cover. This device is provided as a safety feature in case the cover is lowered with the burners on.

Practical Advice on Using the Burners

To use the burners as efficiently as possible, some basic guidelines should be followed:

•Use cookware that is the right size for each burner (see table) in order to prevent the flame from spreading beyond the bottom of the cookware.

•Only use cookware with flat bottoms.

•As soon as the boiling point is reached, turn the knob to the lowest setting.

•Always use lids with pots and pans.

Burner	ř Cookware diameter (cm)
Fast (R)	20 - 24
Semi Fast (S)	16 - 20
Auxiliary (A)	10 - 14

!On models equipped with a reduction grid, the grid should only be used with the auxiliary burner when cookware with a diameter of less than 12 cm is used.

1.To light a specific burner push the

corresponding knob all the way in and turn it counter-clockwise to maximum keeping it pressed down until the burner lights.

2.Turn the control knob anti-clockwise to the desired setting. Only turn the control knob between the large flame symbol and the small flame symbol for adjusting the setting.

3.To turn off, turn the control knob fully clockwise to the symbol O.

DO NOT use the hotplate unless all pan supports are in position.

DO NOT use mis-shapen pans which may be unstable.

DO NOT use round base woks directly on the pan supports.

DO NOT use the glass lid (if fitted) as a working surface.

Each burner is fitted with a spark ignitor for lighting

the gas. To ensure rapid lighting of the burners GB every time they are used, the ignitors must be kept

clean and dry. Remove any food spillage or cleaning materials from the electrode using a small nylon brush such as a tooth brush. Access to the electrode can be achieved by lifting off the loose burner parts carefully when the burners are cool. When the hotplate burner bodies and caps are removed for cleaning, be careful not to drop any food particles or cleaning materials into the burner bases, to avoid the possibility of blocking the gas jets.

If aluminium based pans are used, a silvery deposit may appear on the top edge of the pan support fingers. See 'Care and Cleaning' section for cleaning information.

SAFETY REQUIREMENTS FOR DEEP FAT

FRYING

1.Never fill chip pans more than one third full with oil or fat.

2.Never leave oil or fat unattended during the heating or cooling period.

3.Never heat fat or fry with a lid on the pan.

4.Always dry food thoroughly before frying,

and

lower it slowly into the hot oil or fat. Frozen foods in particular will cause frothing and spitting if added too quickly.

5.Always keep the outside of the pan clean

and

free from streaks of oil or fat.

HOW TO DEAL WITH A FAT FIRE

1.Do not move the pan.

2.Turn off the hotplate burners.

3.Smother the flames with a fire blanket or damp cloth to extinguish the fire. Do not use

water or a fire extinguisher as the

force of itmay spread the burning fat or oil over the

edge of the pan.

4.Leave the pan for at least 60 minutes before moving it.

!After prolonged used of the gas hob there may be some small amount of discolouration in the area around the large burners. This is normal and can be easily removed using propriety stainless steel cleaning agents.

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

11