Automatic cleaning with the FAST CLEAN function
Programming Time
Press the 
button, then:
GB
With the FAST CLEAN mode, the internal temperature of the oven reaches 500°C. The pyrolysis process is activated and burns away food and grime residues. Keep children away from the appliance during the automatic cleaning cycle as surfaces may become very hot.
Particles may ignite inside the oven due to the spontaneous combustion process. Do not worry, this process is both normal and
Before initiating the FAST CLEAN mode:
•Remove large or course food residues from inside of the oven using a damp sponge. Do not use detergents.
•Remove all accessories.
•Do not place tea towels or pot holders over the oven handle.
!If the oven is too hot, pyrolysis may not start. Wait for the oven to cool down.
!The programme may only be started once the oven door has been closed.
To enable the FAST CLEAN mode, turn the SELECTOR knob to
.
Safety devices
•The door is locked automatically as soon as the temperature exceeds a certain value.
•Should a malfunctoin occur, the heating elements will switch off.
•Once the oven door has been locked, you cannot change the cycle time, cycle end and timer settings.
!Programming is possible only after selecting the FAST CLEAN mode.
1.Adjust by turning the THERMOSTAT knob.
2.Press button 
to store the setting.
3.When the selected time has elapsed, END appears on the display and a buzzer sounds.
4.The buzzer can be stopped by pressing any button. The END message disappears when the THERMOSTAT knob returns to position “0”.
A cycle time of between 60 and 120 minutes may be selected, depending on the degree of grime and food residues in your oven.
• For example: it is 9:00 a.m. and a time of 1 hour and 15 minutes is programmed. The programme stops automatically at 10:15 a.m..
Programming End
Press button | and repeat steps 1 to 4 as |
described in the Programming Time procedure.
•For example: it is 9:00 a.m and an end time of 10:15 a.m is programmed. The duration is 1 hour and 15 minutes.
Programme Delayed Cleaning
1.Press button 
and repeat steps 1 to 4 as described in the Programming Time procedure.
2.Then press button 
and set the end time.
•For example: it is 9:00 a.m. and a time of 1 hour and 15 minutes is programmed and the end time is set to 12:30. The programme starts automatically at 11:15 a.m.
The icon | shows that programming has been set. |
To cancel programming, turn the SELECTOR knob to position “0”.
Once the automatic cleaning cycle is over
You will have to wait until the temperature inside the oven has cooled down sufficiently before you can open the oven door. White powder deposits may remain on the bottom and sides of the oven, remove these deposits with a damp sponge once the oven has cooled down completely. Alternatively, you can make use of the already heated oven, in which case it is not necessary to remove the deposits, they are completely harmless and will not affect your food in any way.
13
