Dryer Description
The features
Rating plate
Filter
Condenser cover
Water container
Model & Serial numbers
Condenser cover handle (Pull to open)
Air intake grille
GB
Information | Important |
Installation |
|
Description |
|
Control panel | DRYING LEVELS | TIMER |
| Clean Filter | |
|
| Light | |||
PROGRAMMES | Knob | DRYING Empty Water | Clean Condenser | ||
| Knob | Light | |||
Indicator | Light | ||||
Knob | |||||
|
| ||||
ON/OFF | OPTION | START/PAUSE | Progress or Delay |
Button | Buttons & Lights | Button & Light | Lights |
Programmes | Start and |
Laundry |
|
The ON/OFF button 
: If the dryer is running and this button is pressed and held for more that 3 seconds the dryer is turned off, the programme is then cancelled. Press and hold for more than 3 seconds and the dryer reactivates.
The PROGRAMMES knob sets the programme: rotate it until the indicator is pointing to the programme you want to select or to Timed Drying (see Start and Programmes).
Use the DRYING LEVELS knob to set your required dryness sensing level, or the TIMER DRYING knob to select a drying time (see Start and Programmes).
The OPTION buttons/lights select available options for your selected programme. The lights indicate that the option has been selected (see Start and Programmes).
The START/PAUSE button/light 
starts a selected programme. When you press this button there will be one beep and the progress lights will flash to confirm the action. When a programme is running, holding this button in pauses the programme and stops the dryer.
The light is green when programme is running, flashing amber if the programme has been paused or flashing green if on standby waiting to start a programme (see Start and Programmes).
Note: This light also flashes amber during the Post Care phase of a programme.
The Progress or Delay lights show you the status of the programme, or the delay time when they flash. During a delayed start the lights flash to show the delay selected. When (not flashing) they show each stage of the programme by the corresponding light turning on (see Start and Programmes).
The Empty Water indicator light signals that the water container should be emptied. The light will take a few seconds to go out after replacing the empty water container, the dryer must be running for this to happen (see The Controls).
Note: If the water bottle fills the indicator light flashes, the heat is turned off and your clothes will not dry.
The Clean Filter light gives you a reminder before every programme that it is essential to clean the filter every time the dryer is used (see Maintenance and Care).
The Clean Condenser light gives you a reminder that it is essential to clean the condenser at regular intervals (see Maintenance and Care).
|
|
|
|
|
|
|
|
|
|
Suggestions | Warnings and |
|
|
and Care | Maintenance |
|
|
Troubleshooting |
|
Service |
|
|
|
5
