Hotpoint manual Controls TDL14 and TDL15

The Controls - TDL14 and TDL15

Heat Switch (OUT low heat, IN high heat) Timer Knob

	Drying Guide	Drying Times
TDL14	Turn the timer clockwise to select the required drying time.
	The timer controls the drying time for both heat settings. All you have to do is
	turn the Timer Knob clockwise slightly past the required time and then back to
	the required time.
	Do not rotate the knob beyond 120 (maximum drying time), or past the zero
	stop. If you have selected more time than you required, turn the knob anti-
	clockwise, to select the correct time required.
	This operation also starts the dryer, provided the door is closed and the
	machine is plugged in. The “Guide To Drying Times” section will tell you how
	much time you’ll need for various loads.
TDL15	Turn the timer clockwise to select the required drying time.
	The timer controls the drying time for both heat settings. All you have to do is
	turn the Timer Knob clockwise until it lines up with the required time.
	Never wind the timer control anti-clockwise.
	This operation also starts the dryer, provided the door is closed and the
	machine is plugged in. The “Guide To Drying Times” section will tell you how
	much time you’ll need for various loads.
Heat Selection	The button is ‘OUT’ for LOW heat and ‘IN’ for HIGH heat.
	The choice of FULL HEAT or LOW HEAT depends upon the fabric you wish to
	dry (see section, ‘Sorting your Laundry’)
The ‘Cool	About 10 minutes before the programme is completed, the heating elements
Tumble’ phase	will be switched off, and the programme enters the final ‘Cool Tumble’ phase.
	During this phase, the fabric is cooled. You should always allow the dryer to
	complete this phase.
	By opening the door, the dryer will stop and you can check the dryness of the
	load as often as you wish and, if you want to remove (or add) some items
	before they are fully dry. (This is particularly useful for a mixed load where
	you want to iron some items,but others to be fully dried).
	We recommend that the clothes are removed immediately the programme is
	finished to minimise creasing.
	NEVER SWITCH THE DRYER ‘OFF’ WITH A HOT LOAD IN THE
	DRUM. YOU MUST TERMINATE EVERY PROGRAMME WITH
	THE COOL TUMBLE PHASE.

14