1

Windows users START HERE

2

Unpack the device

 

 

 

 

 

 

This side of the poster is for Windows users only.

Follow the steps on this poster in order.

Do not connect the USB cable until the software

Windows PC

 

prompts you to do so.

 

3

Turn on the computer

 

 

 

Turn on your computer and wait for the Windows PC desktop to appear.

Close any open programs.

Windows PC desktop

4

Begin software installation

 

a

aInsert the Windows HP PSC CD and follow the onscreen instructions.

If nothing appears on your computer screen after you insert the CD, see the Troubleshooting Information chapter in the Reference Guide.

bWhen you see the Set Up Your Device Now screen, leave your computer and proceed to step 5 on this poster. Do not connect the USB cable yet.

5

Windows 98, 2000, ME, XP

Attach the front panel cover

b

b

6

Load plain white paper

7

Connect the power cords

 

 

 

 

 

 

a Remove the adhesive backing from the front panel cover.

a

b

bRaise the lid of the HP PSC. Place the front panel cover into the recess and

stick it into place.

The HP PSC will not work until you attach the front panel cover!

a b

a

b

c

c

ab

8

Connect the USB cable

 

 

 

Make sure that you see the Set Up Your Device Now screen on your computer, then connect the USB cable. Do not connect the USB cable to a keyboard or a non-powered USB hub.

9

Turn on the device

 

 

 

Press the On/Resume button to turn on the HP PSC. Wait for it to finish initializing.

10 Open the print-carriage access door

Lower the print-carriage access door. The print carriage slides to the middle.

Windows setup poster hp psc 1300 series all-in-one

11 Insert and align the print cartridges

a

b

Remove the bright pink tape from

Hold the black print cartridge with the large HP label and

the print cartridges. Do not touch

the raised markings on top. Slide the cartridge at a slight

the gold-colored contacts or

angle into the right side of the print carriage.

retape the cartridges.

Press firmly until the print cartridge snaps into place.

 

Tri-color

Black

c

Hold the color print cartridge with the large HP label and the raised markings on top. Slide the cartridge at a slight angle into the left side of the print carriage.

Press firmly until the print cartridge snaps into place. Make sure that both print cartridges are secure.

d

Close the print-carriage access door. Within a few minutes, a print cartridge alignment page prints.

Place the top of the alignment page face down in the left front corner of the glass. Close the lid.

e

Press the Scan button.

After the On light stops blinking, alignment is complete. Discard or recycle the alignment page.

12 Finish software installation

Hardware setup is now complete. Return to your computer.

Click Next on the screen with the green checkmark. Depending on your system, it may take 20 minutes or more to finish installing the software.

When you restart your computer and the Congratulations screen appears, you are ready to use your HP PSC. If you encounter problems during setup, see the Reference Guide.

Copyright Hewlett-Packard Company 2003

Malaysia.

www.hp.com/support

Printed in Singapore or