Replacing the hard drive

CAUTION: If you are replacing a hard drive, be sure to back up the data from the old drive so that you can transfer the data to the new drive.

1.Turn off the computer properly through the operating system, then turn off any external devices.

2.Disconnect the power cord from the power outlet.

CAUTION: Regardless of the power-on state, voltage is always present on the system board as long as the system is plugged into an active AC outlet. You must disconnect the power cord to avoid damage to the internal components of the computer.

3.Remove the front panel. See Removing the front panel on page 19.

4.Press in the release latch on the left side of the hard drive carrier (1) and then rotate the carrier handle up (2).

5.Lift the hard drive carrier straight up and out of the drive bay.

Replacing the hard drive 23