Problem | Solution |
|
|
No Plug and Play. | In order for the Plug and Play feature of the monitor to work, you need a computer and |
| graphic card that are compatible with Plug and Play. Check with your computer |
| manufacturer. |
| Check the video cable on the monitor, and make sure that none of the pins are bent. |
| Make sure that the monitor drivers are installed. Refer to Installing Drivers on page 16 for |
| more information. Monitor drivers are also available at: www.hp.com/support. |
|
|
Picture bounces, flickers, or | Move electrical devices that might cause electrical interference as far away from the monitor |
wave pattern is present in | as possible. |
the picture. | Use the maximum refresh rate that your monitor is capable of at the resolution that you are |
| |
| using. |
|
|
Using HDMI connection, | The audio stream must be connected directly to external speakers or to an audio receiver. |
unable to hear audio. |
|
|
|
Monitor is always in sleep | Power to the computer should be turned on. |
mode (amber LED). | The computer graphic card should be snugly seated in its slot. |
| |
| Check that the monitor video cable is properly connected to the computer. |
| Inspect the monitor video cable, and make sure that none of the pins are bent. |
| Check that your computer is operational: Press the Caps Lock key and observe the Caps |
| Lock LED found on most keyboards. The LED should either turn on or off after hitting the |
| Caps Lock key. |
|
|
Cannot view 3D content | Install the 3D software included on the CD with the monitor. |
properly. | Use the 3D Passive FPR Glasses included with the monitor. The glasses must be 3D |
| |
| Passive FPR Glasses to view 3D content. The 3D glasses are designed to work with the 3D |
| filter attached to the surface of the monitor. |
| Adjust the monitor's tilt and your viewing angle. |
| Some people are unable to view 3D content. |
|
|
I can see a swirling | This is caused by the interference of external light in the air layer between the LCD surface |
pattern on the monitor when | and the 3D filter. The pattern becomes almost invisible when you turn on the power again. |
the monitor is turned off. |
|
|
|
ENWW | Solving Common Problems 31 |