HP 2510 manual Attach cover and lift display, Connect power cords, Connect supplied phone cord

1Wired/Wireless Network

Start Here - CHOOSE CORRECT POSTER

2Attach cover and lift display

3 Remove tray and load plain white paper

aChoose the one poster that matches your equipment.

If you have an existing

Windows or Macintosh Network setup, follow this poster.

If you do not have a network, see the Direct Connect(USB) poster.

	b Remove all items
	from the carton.
	Remove all tape
	and packaging
	from the
Wired Network	HP PSC.

Wireless Network

aPlace the cover over the top of the

HP PSC. Make sure the buttons are visible.

b Firmly press down on all sides of the cover.

cLift display.

a b c d

4Connect power cords

Connect the power
supply to the	a
HP PSC, and then to	c
the power cord.
Plug into the wall.

b

5Connect supplied phone cord

aYou must connect one end of the supplied phone cord to the phone jack

on the left (1-LINE) and the other end to a wall jack.

bTo connect an answering machine or use your own phone cord, see the Fax Setup chapter in the Reference Guide.

6Turn on and set language and country/region

a Turn power on.

b Select your language, and then press OK. Select your country/region, and then press OK.

1-LINE

Windows/Macintosh (Wired/Wireless) Setup Poster - Side 1 photosmart series all-in-one

7Insert print cartridges

a Lift the print carriage door		b Remove the bright pink
	up until it catches. Lift the	tape from both the print
	blue and gray latches.	cartridges. Do not touch
		the gold-colored contacts
		or retape the cartridges.

cHold the black print cartridge with the label on top as shown. Slide the cartridge underneath the metal bar into the right (gray latch) side of the print carriage.

dHold the color print cartridge with the label on top as shown. Slide the cartridge into the left (blue latch) side of the print carriage.

			Tri-Color	Black
e Pull the end of the gray latch		f	Make sure both latches are
	toward you, press down until it		locked into position. Close
	stops, and then release. Make		the door.
	sure the latch catches below the
	bottom tabs. Repeat with the
	blue latch.

8Align the print cartridges

Press OK on the front panel to begin alignment. Wait a couple of minutes. After a page prints, alignment is complete. Discard or recycle this page.

2500

9Choose Wired or Wireless setup*

Network hp psc

Match the network type to your existing network.

If you do not have an existing network, set one up before attempting to connect the

HP PSC.

Choose a or b, and then turn the poster over.

a Wired network bc Wireless network (infrastructure)

Requirements:	Requirements:
Router/hub/switch	Wireless access point/
	gateway/base station

ETHERNET (CAT-5) cable	ETHERNET (CAT-5) cable
Go to step 10a to set up with a wired network.	Go to step 10b to set up with a wireless network.

Wireless Information:

WPA - If your wireless network uses WPA, configure this on the HP PSC before you install the software. For details see the

Reference Guide, chapter 15, Wireless Network Setup, use the embedded web server.

Compatibility with 802.11g - This HP PSC includes an 802.11b radio that is compatible on 802.11g systems.

*If you have a different network setup, see the Reference Guide.

To set up with a USB cable, please see the other poster for a direct connection (install the software before connecting the USB cable).

Copyright Hewlett-Packard Company 2003 Printed in Germany.