HP 2524, 2512 manual Verification Commands, SwitchA# sh lacp

RESULTING CONFIGURATION:

Switch B (Default configuration.)

HP ProCurve Switch 2524# sh config

IN-FLASH CONFIGURATION

; J4813A Configuration Editor; Created on release #F.01.07

time daylight-time-rule None hostname "HP ProCurve Switch 2524" ip timep dhcp

snmp-server community "public" Unrestricted vlan 1

name "DEFAULT_VLAN" untagged 1-26,Dyn1 ip address dhcp-bootp exit

VERIFICATION COMMANDS:

The following CLI commands can be used to display LACP information:

•show lacp

•show log lacp

Switch_A# sh lacp

			LACP
PORT	LACP	TRUNK	PORT	LACP	LACP
NUMB	ENABLED	GROUP	STATUS	PARTNER	STATUS
----	-------	-------	-------	-------	-------
1	Active	Dyn1	Up	Yes	Success
2	Active	Dyn1	Up	Yes	Success
3	Passive	3	Down	No	Success
4	Passive	4	Down	No	Success
5	Active	Dyn1	Up	Yes	Success
6	Active	Dyn1	Up	Yes	Success
7	Passive	7	Down	No	Success
8	Passive	8	Down	No	Success
9	Passive	9	Down	No	Success
10	Passive	10	Down	No	Success
11	Passive	11	Down	No	Success
12	Passive	12	Down	No	Success
13	Active	Dyn1	Standby	Yes	Success
14	Passive	14	Down	No	Success
15	Passive	15	Down	No	Success
16	Passive	16	Down	No	Success
17	Active	Dyn1	Standby	Yes	Success
18	Passive	18	Down	No	Success
19	Passive	19	Down	No	Success
20	Passive	20	Down	No	Success
21	Passive	21	Down	No	Success
22	Passive	22	Down	No	Success
23	Passive	23	Down	No	Success
24	Passive	24	Down	No	Success
25	Passive	25	Down	No	Success
26	Passive	26	Down	No	Success

©Copyright Hewlett-Packard Company, 2000.	Page 4
All rights reserved.