yourYour Blender blender

After unpacking the blender, wash everything except the blender base in warm, soapy water. Dry thoroughly. Do not place in dishwasher. Wipe the blender base with a damp cloth or sponge. Do not immerse the base in water. Care should be taken when handling the blades, as they are very sharp.

How to Assemble and Use

Important: Your blender jar and cutting blades are subject to wear during normal use. Always inspect cutting blades for broken, cracked or loose blades. If jar or cutting blades are damaged, do not use. Call our toll-free customer service number to obtain replacement parts.

•Make sure blender is unplugged. Place blender base on clean, dry surface to keep foreign particles from being pulled up into motor during operation.

•Make sure gasket is in place on outer rim of blade assembly. The gasket must lie flat. Screw the blade assembly counterclockwise into the jar base firmly using the finger tabs on the bottom of blade assembly.

•To easily assemble into the jar, tilt the blade assembly slightly and enter with the serrated

blade that curves up. Move as needed to clear the

 

remaining blades. When seated properly, turn the

 

blade assembly counterclockwise to tighten. To

 

remove, just reverse the process; turn the blade

 

assembly clockwise and lower slightly and in the

 

direction of the serrated blade tilt up and the

FIGURE 1

other blades will clear the jar bottom opening.

 

FIGURE 1

 

• NOTE: The blade assembly will turn counter

 

clockwise to tighten and clockwise to loosen.

 

• The transparent filler-cap is designed to assist in

 

tightening and loosening the blade assembly if

 

necessary. FIGURE 2

 

• Remove the filler-cap from its position in the jar

 

lid and note the notches in the bottom (open)

FIGURE 2

end. These notches or slots engage the ribs on the

 

3