Installing the New Optical Drive

NOTE: If you are installing an optical drive in a bay that did not previously have a drive in it, you must remove the access panel and the bezel blank covering the opening of the bay before proceeding. Follow the procedures in Removing the Computer Access Panel on page 9 and Removing a Bezel Blank on page 13.

1.Attach the release latch to the new optical drive. Refer to Preparing the New Optical Drive on page 20.

2.With the back of the optical drive facing the computer and the release latch on the inner side of the drive, align the drive with the opening in the front bezel.

3.Slide the optical drive through the front bezel all the way into the bay so that it locks in place (1), then connect the cable to the rear of the drive (2).

Figure 2-13Installing the Optical Drive

4.Replace the access panel.

5.If the computer was on a stand, replace the stand.

6.Reconnect the power cord and turn on the computer.

7.Lock any security devices that were disengaged when the computer cover or access panel was removed.

ENWW

Replacing the Optical Drive 21