1.Unsolder the red and black speaker cables (1) from the system board speaker contact points.

NOTE: When installing the speaker, the red speaker cable should be soldered to the system board speaker “positive” terminal. The black speaker cable should be soldered to the system board speaker “negative” terminal.

2.Release the speaker cables from the retention clips (2) built into the speaker.

3.Remove the two Phillips PM1.4×3.6 screws (3) that secure the speaker to the display panel assembly.

4.Remove the speaker (4).

Reverse this procedure to install the speaker.

18 Chapter 5 Removal and replacement procedures

Page 24
Image 24
HP 7 Plus II 1331 manual