boot

OVERVIEW

Category:

Switch Management

Primary context:

manager

 

 

Related Commands

reload (page 467)

 

 

Usage: boot [system [flash <primarysecondary>] [config FILENAME]] boot set-default flash <primarysecondary>

boot active boot standby

Description: Reboot the device. The primary or secondary software image can be specified to be used during the boot process. Optionally, a configuration file can be set for this boot.

Parameters:

 

Sets the default flash boot image for next boot.

o set-default-

o active

-

Causes switchover and reboots the active management

 

 

module, if redundancy is enabled and the other module

 

 

is present. Reboots the system if redundancy is disabled

o standby

-

or the module is not present.

Reboots the standby management module.

NOTES

Italicized "config" Keywords

The italicized "config config1" keywords correspond to the names selected for the config files.

COMMAND STRUCTURE

■boot active -- Reboot the active management module. (p. 73)

■boot set-default-- Specify the default flash boot image. (p. 74)

■flash < primary secondary > -- Specify the default flash boot image. (p. 74)

■boot standby -- Reboot the standby management module. (p. 74)

■boot system -- Allows user to specify boot image to use after reboot. (p. 75)

■flash < primary secondary > -- Specify boot image to use after reboot. (p. 74) ■ config < config config1 > -- Specify configuration file to use on boot. (p. 74)

COMMAND DETAILS

active (p. 73)

flash (p. 74)

standby (p. 74)

config (p. 74)

set-default (p. 74)

system (p. 75)

 

 

 

active

■boot active

Note: This command applies to the 8212zl switch only.

Reboot the active management module. The switch starts to boot from the default flash image. You can select which image to boot from during the boot process itself. The switch will switchover to the standby management

© 2009 Hewlett-Packard Development Company, L.P.

73