Command Line Interface Reference Guide

boot

 

 

module. If a second management module is not present in the switch, the system is rebooted.

config

■boot system flash < primary secondary > config < config config1 >

Specify configuration file to use on boot.

Supported Values:

■config

■config1

flash

■boot system flash < primary secondary >

Specify boot image to use after reboot.

Supported Values:

■primary -- Primary flash image.

■secondary -- Secondary flash image.

Next Available Option:

■config < config config1 > -- Specify configuration file to use on boot.(p. 74)

■boot set-default flash < primary secondary >

Specify the default flash boot image.

Supported Values:

■primary -- Primary flash image.

■secondary -- Secondary flash image.

set-default

■boot set-default

Specify the default flash boot image. Sets the default flash for the next boot to primary or secondary. You will see this message:

“This command changes the location of the default boot. This command will change the default flash image to boot from <flash chosen>. Hereafter, ‘reload’ and ‘boot’ commands will boot from <flash chosen>. Do you want to continue [y/n]?”

Next Available Option:

■ flash < primary secondary > -- Specify the default flash boot image.(p. 74)

standby

■boot standby

Reboot the standby management module. The switch does not switchover. If the standby module is not present, this message displays: “The other management module is not present.”

© 2009 Hewlett-Packard Development Company, L.P.

74