Remove the system board:

1.Disconnect the following cables from the system board:

(1)TouchScreen ZIF connector and cable

(2)Controller ZIF connector and cable

(3)Speaker cables (must be unsoldered, see Speakers on page 19)

(4)Power/button board ZIF connector and cable

(5)Front-facing webcamera cable

(6)Antenna cable (must be unsoldered, see Antenna on page 22)

(7)Rear-facing webcamera cable

(8)Microphone cable (must be unsoldered, see Microphone on page 20)

2.Remove the three Phillips PM1.5×2.5 screws (1) that secure the system board to the display panel assembly.

3.Detach the left side of the system board (2) from the display panel assembly. (The left side of the system board is attached to the display panel assembly with double-sided adhesive.)

24

Chapter 5 Removal and replacement procedures