HP AA-RW7CE-TE Configure and verify the host, Verifying configuration settings

Configure and verify the host

Verifying configuration settings

Verify that all paths to the storage system are present with cfgadm -alcommand. To display the LUNs configured to each path, execute cfgadm -al-o show_FCP_dev as shown in the example below.

The following examples are with 4 paths (ports) visible from the array on the host and with 2 LUNs configured on the array for the host. You should normally see 4 paths with EVA3000/ EVA5000/ EVA4000/ EVA6000, however you might also see up to 8 paths with EVA8000.

1.Enter the cfgadm command to verify the paths to the LUNs (note that you need to have configured LUNs on the array for the host in order to see the “disk” lines):

Example: # cfgadm -al -o show_FCP_dev		Receptacle	Occupant	Condition
Ap_Id	Type
c2	fc-fabric	connected	unconfigured	unknown
c2::50001fe1002709f8,0	array-ctrl	connected	unconfigured	unknown
c2::50001fe1002709f8,1	disk	connected	unconfigured	unknown
c2::50001fe1002709f8,2	disk	connected	unconfigured	unknown
c2::50001fe1002709fc,0	array-ctrl	connected	unconfigured	unknown
c2::50001fe1002709fc,1	disk	connected	unconfigured	unknown
c2::50001fe1002709fc,2	disk	connected	unconfigured	unknown
c3	c-fabric	connected	unconfigured	unknown
c3::50001fe1002709f9,0	array-ctrl	connected	unconfigured	unknown
c3::50001fe1002709f9,1	disk	connected	unconfigured	unknown
c3::50001fe1002709f9,2	disk	connected	unconfigured	unknown
c3::50001fe1002709fd,0	array-ctrl	connected	unconfigured	unknown
c3::50001fe1002709fd,1	disk	connected	unconfigured	unknown
c3::50001fe1002709fd,2	disk	connected	unconfigured	unknown

With Solaris 8 or 9, the Occupant status will be displayed Solaris 10 (SPARC and x86), you will see a configured

as above in a SAN environment. With status.

2.For Solaris 8 and 9, use cfgadm -c configure c# command to configure the host to access the storage system as shown in the example below. The value of # is gathered from the output of the cfgadm -alpreviously executed.

Example:

#cfgadm -c configure c2

#cfgadm -c configure c3

3.Execute the cfgadm command to view configured devices. After the configuration, the following command will show the array controllers as configured:

#cfgadm -al

Ap_Id	Type	Receptacle	Occupant	Condition
c0	scsi-bus	connected	configured	unknown
c0::dsk/c0t0d0	disk	connected	configured	unknown
c0::dsk/c0t6d0	CD-ROM	connected	configured	unknown
c1	scsi-bus	connected	unconfigured	unknown
c2	fc-fabric	connected	configured	unknown
c2::50001fe1002709f8	array-ctrl	connected	configured	unknown
c2::50001fe1002709fc	array-ctrl	connected	configured	unknown
c3	fc-fabric	connected	configured	unknown
c3::50001fe1002709f9	array-ctrl	connected	configured	unknown
c3::50001fe1002709fd	array-ctrl	connected	configured	unknown

6