Deploying a single version of the software across different models of systems
A single version of HP Backup and Recovery Manager supports many different models/systems; therefore, you can install a single version on any supported system.
Installing on multiple partitions
Installing Backup and Recovery Manager on a drive with multiple partitions is supported for Desktops, but not supported for Portables. However, you can add partitions after installing Backup and Recovery Manager.
The following workaround may allow you to install the application: 1. Reformat a
2. Use RDEPLOY to create a
3. Using WinPE, use DISKPART to create an empty
4. Allow the factory image to completely install HP Backup and Recovery Manager and all associated software.
Reimaging a hard drive
HP Backup and Recovery Manager supports installation on multiple partitions in Desktops. It does not support installing with multiple partitions for Portables. You can add additional partitions and disks after installation.
After laying down an image on a
In this situation, WinPE creates a PAGEFILE.SYS on the hard drive due to the WINBOM.INI in the HP Backup and Recovery partition. DISKPART cannot alter the C partition when WinPE accesses it.
To
●Edit the WinPE build to prevent using the WINBOM.INI in the HP Backup and Recovery partition or
●Remove WINBOM.INI from the HP Backup and Recovery partition.
1. Rebuild the WinPE CD image so the registry points to a known good WINBOM.INI. The path and file name specified by the registry key is: HKEY_LOCAL_MACHINE\SOFTWARE\Microsoft\Factory \Winbom.
NOTE: In general, WinPE might pick up other WINBOM.INI files elsewhere in the system. To make sure you are using the correct WINBOM.INI file, use the registry setting.
2. Rename or delete WINBOM.INI in the HP Backup and Recovery partition, and then reboot WinPE.
In the case of reimaging, deleting the WINBOM.INI file is an option, but if you do this when you do not want to
ENWW | Installation 7 |