Error Messages and Codes
A.3 Power-On Self Test (POST) Messages
Table
Error Message | Probable Cause |
|
|
Invalid Electronic Serial Number | Chassis serial number is corrupt. Use Setup to enter a valid number. |
|
|
Network Server Mode Active (w/o | System is in network mode. |
kybd) |
|
|
|
A device’s option ROM has failed/is bad. | |
|
|
Recently added PCI card contains and option ROM too large to | |
Option ROMs | download during POST. |
|
|
Failed ESCD write, A20, timer, or DMA controller. | |
|
|
An option ROM failed to execute on a previous boot. | |
|
|
Invalid checksum, RTC lost power, or invalid configuration. | |
|
|
Date and time information in CMOS is not valid. | |
|
|
Memory has been added or removed. | |
|
|
Memory test failed. | |
|
|
BIOS detected installed DIMM(s) as being not compatible. | |
|
|
A specific error has occurred in a memory device installed in the | |
| identified socket. |
|
|
Installed memory exceeds the maximum supported by the system. | |
|
|
Unbalanced memory configuration. | |
|
|
Recently added memory module(s) support ECC memory error | |
Detected ECC Modules not | correction. |
supported on this platform |
|
|
|
Keyboard interface test failed (improper connection or stuck key). | |
|
|
Keyboard buffer failed empty (8042 failure or stuck key). | |
|
|
Keyboard controller failed | |
|
|
Current parallel port address is conflicting with another device. | |
|
|
NIC BIOS could not read Device ID of embedded NIC. | |
|
|
Graphics display controller. | |
|
|
Corrupted splash screen image. Restore default image w/flash utility. | |
|
|
Processor heat sink fan is not connected. | |
|
|
Chassis fan is not connected. | |
|
|
| www.hp.com | Technical Reference Guide |