1 Connecting to a Netware 3.12 Server

Windows for Workgroups

Windows for

Workgroups

1 Connecting to a Netware 3.12 Server

Requirements

•HP Vectra with DOS and MS-Windows for Workgroups 3.11 installed.

•3COM Etherlink 3C900 Ethernet card and drivers disk ver 2.1. DOS ODI - File Name: 3C90X.COM Size: 59KB Date: 12/18/96

•DOS and MS-Windows for Workgroups 3.11 media.

•Novell Netware server that supports Net BEUI, NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.

•Netware client for DOS and MS-Windows.

Device Configuration

•

Network Driver Optimization

Normal

•

Full Duplex

Disabled

•

Boot PROM

Disabled

•

Media Type

10BASE-T

•

I/O Base Address

FCC0h (PCI)

•

Interrupt Request Level

9 (PCI)

Procedure

1With the HP Vectra turned off install the 3COM Etherlink III 3C900 adapter card into a PCI slot.

2Power on the machine and allow it to boot to a DOS prompt.

3Insert the 3COM drivers diskette (ver. 2.1 downloaded from 3COM’s website) and execute 3C90XCFG.EXE.

4Select “CONFIGURE NIC,” and verify the resource settings listed above under the heading “Device Configuration.”

5If changes are required, save those changes and exit.

6Remove the 3com cards driver diskette and insert Netware client for DOS and MS-Windows disk 1.