Recognizing Preset Display Resolutions

The display resolutions listed below are the most commonly used modes and are set as factory defaults. This monitor automatically recognized these preset modes and they will appear properly sized and centered on the screen.

LE1711 and LE1911 Models

Table B-3Factory Preset Modes

Preset

Pixel Format

Horz Freq (kHz)

Vert Freq (Hz)

 

 

 

 

1

640 × 480

31.469

59.940

 

 

 

 

2

720 × 400

31.469

70.087

 

 

 

 

3

800 × 600

37.879

60.317

 

 

 

 

 

4

1024

× 768

48.363

60.004

 

 

 

 

 

5

1280

× 960

60.00

60.00

 

 

 

 

 

6

1280

× 1024

63.98

60.02

 

 

 

 

 

Entering User Modes

The video controller signal may occasionally call for a mode that is not preset if:

●You are not using a standard graphics adapter.

●You are not using a preset mode.

It this occurs, you may need to readjust the parameters of the monitor screen by using the on-screen display. Your changes can be made to any or all of these modes and saved in memory. The monitor automatically stores the new setting, then recognizes the new mode just as it does a preset mode.

Energy Saver Feature

When the monitor is in its normal operating mode, the monitor uses less than 28 watts and the Power light is green.

The monitor also supports a reduced power state. The reduced power state will be entered into if the monitor detects the absence of either the horizontal sync signal and/or the vertical sync signal. Upon detecting the absence of these signals, the monitor screen is blanked, the backlight is turned off, and the power light is turned amber. When the monitor is in the reduced power state, the monitor will utilize less than 1 watt of power. There is a brief warm up period before the monitor will return to its normal operating mode.

Refer to the computer manual for instructions on setting energy saver features (sometimes called power management features).

NOTE: The above power saver feature only works when connected to computers that have energy saver features.

By selecting the settings in the monitor's Energy Saver utility, you can also program the monitor to enter into the reduced power state at a predetermined time. When the monitor's Energy Saver utility causes the monitor to enter the reduced power state, the power light blinks amber.

Recognizing Preset Display Resolutions 29