Connecting hp StorageWorks SAS tape drives to

hp ProLiant ML150 G3 servers using the supplied cable

The option of this server that provides support for SAS hard drives uses an HP 8 Internal Port SAS with RAID controller. The most cost-effective way to connect the SAS tape drive to the server is to use the special cable supplied with the tape drive.

This installation requires you to remove one of the existing SAS cables and replace it with the cable supplied with the tape drive. This does not affect your existing hard disk drive configuration. (If this cabling solution is not acceptable, you must purchase and install a new, supported SAS HBA.)

1. Locate the cable to be removed

These servers support up to 6 hard disk drives. You need to replace the cable that connects to hard disk drives 5 and 6.

2. Identify the SAS port on the SAS controller

Trace the other end of the cable back to the SAS controller card to identify the SAS port to which it is connected.

The poster supplied with your tape drive provides detailed instructions about replacing the cable and installing the tape drive.