3.Configure the recovery cluster at the third datacenter.

4.Configure RAID Manager in the primary and recovery clusters.

5.Create Device Group pairs.

6.Assign Remote Command Device to Journal Volumes.

7.Configure LVM Volume Groups.

8.Configure VxVM disk groups.

9.Install and configure the application in the primary cluster.

10.Configure a primary package in the primary cluster using the 3DC modules.

11.Start the primary packages in the primary cluster.

12.Install and configure the application in the recovery cluster.

13.Configure a recovery package in the recovery cluster using the 3DC modules.

14.Configure Continentalclusters and Continentalclusters Recovery Group.

NOTE: This section provides information about configuring a single-instance application in a 3DC environment. For configuring a complex workload in a 3DC environment using SADTA, in addition to this section, see section “Deploying a Complex Workload in Three Data Center Solution using SADTA” (page 447)

Install the required software on all nodes in the 3DC DR Solution

To configure an application in the 3DC environment, all the required software products and related patches must be installed. Install these software products and patches on all nodes in the 3DC DR Solution.

For information about softwares required and supported versions, see Serviceguard Disaster Recovery Products Compatibility and Feature Matrix (Metrocluster with Continuous Access for P9000 and XP) available at http://www.hp.com/go/hpux-serviceguard-docs –> HP Serviceguard Metrocluster with Continuous Access for P9000 and XP.

Configuring the Primary Cluster

Create a Serviceguard cluster (Metrocluster) using the nodes in Site 1 and Site 2 using the procedure described in the Managing Serviceguard manual available at http://www.hp.com/go/ hpux-SG-docs. While deploying complex workloads using SADTA, Metrocluster must be created with two sites defined in the cluster configuration file using the procedure described in the section “Configuring Metrocluster with Sites” (page 346). This Metrocluster acts as a primary cluster in the Continentalclusters environment.

Configuring the Recovery Cluster

Create another Serviceguard cluster in Site 3 using the procedure described in the Managing Serviceguard manual available at http://www.hp.com/go/hpux-SG-docs. While deploying complex workloads using SADTA, Serviceguard cluster must be created with a single site defined in the cluster configuration file using the procedure described in the section “Configure the Recovery Cluster” (page 451). This cluster acts as a recovery cluster in the Continentalclusters environment.

Configuring RAID Manager in the Primary and Recovery Cluster

The P9000 or XP RAID Manager Host-based software is used to create and manage the device group pairs in a Three Data Center configuration. The following section describes the RAID manager configuration process.

Use the following steps to create the RAID manager configuration:

1.Edit the /etc/services file and add an entry for the Raid Manager instance that has to be used with the cluster. The format of the entry is:

horcm<instance-number> <port-number>/udp

Example:

430 Designing a Three Data Center Disaster Recovery Solution