Hardware Upgrades
4.Insert the new flash memory with the membrane circuitry facing down as shown in the following illustration.
Installing optional flash memory (T20 model shown)
5.Attach the side access panel.
6.Power up the Thin Client.
7.Upgrade the Thin Client firmware if necessary.
T30 Flash Memory Installation
The T30 Thin Client can be upgraded with two physically different types of flash. Use these steps as a general installation overview. Refer to the documentation included in your flash memory option kit for detailed instructions on installing T30 flash memory.
1.Follow the applicable instructions in the “General Hardware Installation Sequence” section at the beginning of this chapter.
2.Access the Thin Client system board.
3.Remove any existing flash memory if installed.
Hardware Reference Guide |