Using HDLC.FRAME Protocol
Status and Error Messages
| E1/T1 interface |
|
| The following unsolicited status codes may be received by an application | |
| program from the HDLC.FRAME protocol on an E1/T1 interface. | |
Table | E1/T1 Interface Unsolicited Status Codes | |
|
|
|
| Unsolicited | Description |
| Status Code |
|
|
|
|
| IO_OK | No error detected. |
|
| Normal communications have been established or |
|
| resumed. |
|
|
|
| IO_DSBL | Terminal Disabled |
|
|
|
| IO_TX_TMOUT | Cable or local modem fault. |
|
| The physical connection to the remote device has been |
|
| lost. |
|
|
|
| IO_LONG_MSG | Frame too long (SS7 only) |
|
| HDLC.FRAME has entered octet counting mode. |
|
|
|
| IO_RX_BUF | No receive buffers |
|
| The number of available free buffers or message headers |
|
| on the interface card is dangerously low. |
|
|
|
| IO_ALRDY_ENBL | Terminal already enabled |
|
| An enable request was received for an HDLC.FRAME |
|
| terminal which was already enabled. |
|
|
|
| IO_ALRDY_DSBL | Terminal already disabled |
|
| A disable request was received for an HDLC.FRAME |
|
| terminal which was already disabled. |
|
|
|
| IO_STATS | This message is sent in response to a CW_STATS control |
|
| write. The data buffer contains an l2stat_type |
|
| structure (defined in fw_types.h). The l2stat_type |
|
| structure is the same as the x25l2stat_type structure |
|
| mentioned above, except that it has some additional |
|
| fields. |
|
|
|
30 | Chapter 3 |
