Hubbell K24 manual Hose Removal, Hose Installation Reference Drawing, Gleason Reel Corp

10.Connect free end of hose to connections on machine or adjust hose stop so that desired length of hose extends from reel.

11.Tension spring with spanner wrench. Refer to INSTALLATION section.

12.Replace inspection cover.

SPOOL

SHAFT

SIDE VIEW Figure 4

PAWL

SPRING

Install

against flat

SPRING HUB (Spring not

shown)

END VIEW	SHAFT
	GROOVE

HOSE REMOVAL

Use the following procedure to remove worn or damaged hoses from reel prior to installation of new hoses.

1.Move machine serviced by reel to a position closest to reel. Spring will still be under pre-tension at this point.

2.Turn off supply pressure to reel.

3.Disconnect hoses from machine or other attachments. Remove hose stops, if installed, and allow hoses to retract onto spool. Ensure all tension is off spring by manually rotating spool (normally clockwise when viewed from spring side).

4.Unwrap hoses without allowing spool to turn.

5.Disconnect hoses from elbows inside spool wrapper.

6.Install new hoses following directions below.

HOSE INSTALLATION

Use the following procedure to replace hoses or if reel was ordered without hoses. Refer to HOSE INSTALLATION REFERENCE DRAWING, below.

1.Unspool new hose from shipping spool and lay out to eliminate twist.

NOTE: This step is not essential, but will aid in winding operation of the reel and prolong hose life.

2.Connect hoses to elbows inside spool wrapper. (See drawing below.)

3.Wind the hose onto the reel spool by hand rotating spool in direction it turns free of spring tension. (Normally clockwise when viewed from spring side)

4.Complete working end connections.

5.Pretension reel and complete installation as described in REEL INSTALLATION section.

HOSE INSTALLATION REFERENCE DRAWING

	STANDARD SPOOL ROTATION
	DIRECTION TO WIND HOSE WHEN
	VIEWED FROM FITTING SIDE
	SPOOL
	DISK
	SPOOL
CONNECT	DISK
SPOOLED	HOSE ON
HOSES
HERE	SPOOL
	SWIVEL
	FITTING
	SUPPLY
	LINES
SPOOL
WRAPPER
SECTIONS	NOTE: SUPPLY
	MUST BE FLEXIBLE
VIEW FROM FITTING SIDE	LINE. DO NOT HARD
	PLUMB.

REEL

FRAME

SPRING

MOTOR

MOUNTING

BASE

GLEASON REEL CORP.

P.O. Box 26 • 600 South Clark St.

Mayville, WI 53050–0026

Phone 920–387–4120 • Fax 920–387–4189

Printed in USA Bulletin No. 052763.b