Hubbell SZ-32 Cable Installation & Removal, Carefuly read and follow instructions, Cable Removal

CABLE INSTALLATION & REMOVAL

Use the procedure detailed on HAZARDOUS DUTY CABLE REEL SEALING INSTRUCTIONS (bulletin 039789) which comes with sealing kit (available separately).

CAUTION

Carefuly read and follow instructions

supplied with separate sealing kit as well as instructions for sealing compound. Failure to properly follow those instructions could result in damage to equipment, personal injury or death.

CABLE REMOVAL

CAUTION

Always open all breakers and disconnect electrical power to reel. Failure to turn off electrical power could lead to serious injury or death.

1.Move machine serviced by reel to a position closest to reel. Springs will still be under pre-tension at this point.

2.Turn off all power to reel.

3.Remove collector cover and gasket.

4.Disconnect electric leads to and from collector.

5.Follow Steps 3–9, REMOVING OLD CABLE,

on bulletin 039789.

CABLE INSTALLATION REFERENCE DRAWING

		COLLECTOR		COLLECTOR
U-BOLT			ENTRANCE
				COVER
SPOOL	LOCKING			COLLECTOR	COLLECTOR
SPRING	COLLAR				ENCLOSURE
				SHAFT
					COLLECTOR
HOUSING
					ENCLOSURE
					ASSEMBLY
					Shown in Fig 2
					without cover.
					CONDULET
					NIPPLE
				COLLECTOR	NOTE: This is FACTORY
					SEALED. Check seal
SPOOL SHAFT	DRIVE		DRIVE	INSTALLED CABLE	integrity when
					installing new cable.
WATER TIGHT	STOP BOLT		BRACKET
CONNECTOR

HUBBELL

	GLEASON REEL CORP.
®	P.O. Box 26 • 600 South Clark St.
	Mayville, WI 53050–0026
®	Phone 920–387–4120 • Fax 920–387–4189
A Hubbell Company

Printed in USA Bulletin No. 044625.a