Surface Mounted Thermostat | Hubbell Electric Heater Company MSE

SURFACE MOUNTED THERMOSTAT

1.Disconnect power from unit.

2.Remove access cover and locate thermostat.

3.Disconnect the two (2) 14 gauge wires.

Control Wires

4. Remove two (2) mounting screws.

Mounting Screws

5. Replace thermostat using the reverse procedure.

22

Image 22

Hubbell Electric Heater Company MSE manual Surface Mounted Thermostat

Contents

Electric Heater Company BOX Hubbell Electric Heater CompanySTRATFORD, CT Table of Contents Section Title Page Tank Connections Section I General Description and ConstructionTank Heating Element Temperature High Limit Switch Control Thermostat Options Magnetic ContactorOuter Shell and Insulation Low Water Cut-Off Fused Low Voltage Transformer Dial Temperature and Pressure GaugeVacuum Relief Valve Individually Fused Elements On/Off SwitchElectro-Mechanical Timer Built-in Circuit Breaker Water Heater Placement Securing of Heater Mounting Dimensions Piping Installation Filling the Heater Electrical Installation Final Checks Freezing Section III Scheduled Maintenance and OperationMaintenance and Operation Quarterly Inspection Annual Inspection Section IV Troubleshooting Symptom Probable Cause Corrective Action / RemedyPage Section V Servicing & Replacement of Parts Surface Temperature High Limit CUT-OFF Immersion Temperature High Limit CUT-OFF Heating Element Page Surface Mounted Thermostat Immersion Thermostat Magnetic Contactor Relief Valve Section VI Miscellaneous Charts and Formulas Element Chart Formulas Torque Values Section VII ABS Type Approval Program Page Page