Grommet

Fan

Blade

Figure 13

NOTE: Grommets are usually assembled by hand. If you use a tool, make certain you do not damage the grommet or blade when inserting the grommets.

4. With some fans you have an option to install

four or five blades. For five blades, mount to the outer row of holes on the motor. For four blades, use the inner row. See Figure 14.

Figure 14

5.To install the blades to the motor, insert the blade iron screw through the hole in the blade iron. Use a screwdriver to hold in place.

6.Fasten the screw onto the motor, but do not overtighten. See Figure 15.

7.Line up the other hole on the motor and fasten the second screw.

NOTE: Before tightening the screws, make sure they are not cross-threaded in the mounting holes.

8.Tighten both screws securely. Repeat for the remaining blades.

!CAUTION!

•Do not attempt to run the fan until all screws have been tightened securely.

9.A blade balancing kit has been provided with your fan. Should the fan wobble in operation, you may use this kit to correct the balance per the instructions supplied with the kit.

Step 8: Operation of Your Hunter Fan

1.The operation of your fan is controlled with a pull-chain switch, which has four (4) positions: Off -- High -- Medium -- Low. Pull the chain gently to obtain the speed you desire.

2.The Break-A-Way Connector is designed to separate from the chain at a predetermined force. If this separation occurs, simply reinsert the connector. It can be used again and again. See Figure 16.

Figure 16

3.Reversing your fan is controlled by a small switch located on the switch housing. See Figure 17.

NOTE: Ceiling fans are usually adjusted once in the fall and again in the spring to blow upward in the winter and downward in the summer. You may run them in either direction at anytime, however, as you prefer. Experiment as you like to obtain maximum comfort from your fan.

Figure 15

 

Figure 17

 

 

 

 

© 2003 HUNTER FAN CO.

6

41556-01

8/08/03