Hanging The Fan
! CAUTION !
TO SECURELY HANG THE FAN, CAREFULLY FOLLOW THE STEPS ON PAGES 7 AND 8. BE SURE TO TIGHTEN THE HANGER PIPE INTO THE FAN AND THE HANGER BRACKET ONTO THE PIPE. TIGHTEN THE 2 SET SCREWS, AS DESCRIBED IN STEP 7, TO PREVENT THE FAN FROM FALLING. YOUR FAN MAY WEIGH UP TO 50 LBS. ALL OF THE FOLLOWING STEPS MUST BE FOLLOWED IN ORDER TO ENSURE A SECURE MOUNTING.
1.Feed the wires from the top of the fan motor through the hanger pipe (see Fig. 3).
2.Loosen the motor housing set screw (do not completely remove from the fan) in the neck of the fan motor housing.
3.Screw the pipe into the fan until tight (at least 4 1/2 turns) (see Fig. 4).
4.Excess wiring can be cut, but leave at least 8" extending from the top of the downrod.
NOTE: Some of the pipe threads may still be visible.
Wires | Hanger Pipe |
|
Motor
Housing
Motor Housing
Set Screw
Fig. 3 | Fig. 4 |
Hunter Fan Company
7 
