41451-01 14
Programming
User Programming
User programming allows you to set when the air purifier is on and what blower speed to
use. You may define up to 4 programs for the weekdays and up to 4 programs for the week-
end. Before starting the programming process, first you should determine what times and
blower speeds will best fit your needs. Use the charts below to organize and record the
programs that you desire. Use a pencil so you can re vise your records each time you change
the programs.
Table 4
NOTES:
•Setpoint time is the time at which the blower speed will change. The specified blower
speed will be active until the next setpoint time is reached.
•The setpoint time can only be set in 10 minute increments.
•Blo wer speed ranges from 0 to 3. Zero indicates that the blower is turned of f, a setting of
1 is low, 2 is medium, and 3 represents a blower speed of high.
•If you want the weekdays and the weekends to be identical, you should program both the
weekday programs and the weekend programs with the same values.
•If you use less than 4 programs, set the unused programs identical to one of the other
programs. Table 5 below gives an example where programs 3 and 4 are identical.
Table 5: Using 3 of the 4 Available Programs
Program Setpoint Time Blower Speed
18:00 am 3
25:00 pm 2
39:30 pm 1
49:30 pm 1
WEEKENDS
Program Setpoint Blower
Time Speed
1
2
3
4
WEEKDAYS
Program Setpoint Blower
Time Speed
1
2
3
4
41451-01_Rev 8-6-04.pmd 8/5/04, 5:05 PM14