Operation

Initial Operation

This section provides basic instructions on the use of your air purifier. After following these initial directions, please continue reading this booklet to learn how to operate the more advanced features of your air purifier.

Basic Operation of the Air Purifier:

1.Take the air purifier out of the box and remove the clear plastic protective bag. Place the unit on a firm level floor.

2.Before turning on the air purifier, you need to confirm that the filters are firmly in place and have not become loose during shipping. To check the filters, open the front grill by placing your fingers under the handle and pulling the front grill towards you. The front grill will rest open at about 45º. You can remove the front grill by placing your fingers under the handle and pulling the front grill towards you and then up.

HANDLE

PULL

FORWARD,

THEN UP

Fig. 5

Fig. 6

3.Next, check the HEPA filter by pressing firmly on all four corners of the filter to ensure that it is fully inserted into the filter opening.

4.The carbon pre-filter is mounted inside the front grill with hook tape. Confirm that it properly covers the grill vents. You may notice a few black particles com- ing off the pre-filter. Those particles are part of the odor-removing activated car- bon and will be collected on the filter during use.

5.Place the front grill back onto the unit. First, line up the tabs on the bottom of the grill with the openings on the purifier base and then push the top of the grill forward until it is closed. NOTE: This unit will not operate unless the grill is in the correct position.

41960-01

 

6

41960-01_rev 1-13-06.pmd

6

1/13/06, 4:50 PM