2 | Using Your Humidifier |
|
| ||
| Initial Setup and Operation |
|
Initial Setup
1. Remove the Hunter® Evaporative Humidifier from its packaging.
2. Place the humidifier on a hard, flat, water resistant surface. Always place the humidifier at least six (6) inches away from walls and sources of heat.
3. Make sure the power/speed control is in the ‘OFF’ position.
NOTE: The power/speed control should always be off before unplugging the humidifier, moving the humidifier, or refilling the water tank.
4. Lift the housing to ensure the wick is properly seated, resting on the bottom of the water tray and not tilted or otherwise out of position. Figure 1. Place the housing back on the water tray.
5. Grasp the water tank by the tank handle and remove it from the water tray. Figure 2.
6. Turn the water tank
7. Fill the water tank with clean, cool water and return the tank cap to its position. Tighten it by turning clockwise, and return the water tank to the water tray.
8. Plug the humidifier’s power cord into a standard household power outlet.
9. Turn the power/speed control to your desired humidifier fan speed.
Operation
Wick
Figure 1.
Tank Handle 
Figure 2.
Off Turns the unit off.
Low: Extends the time between refills by running the fan on low. Lowest noise setting recommended for nighttime use.
High: Average refill rate and optimal for day use. Minimal noise level.
To turn on or off the Niteglo™ Nitelight, just press the Niteglo™ Button on the top of the unit.
See Figure 4. for a display of your controls.
If you choose to use vapor pads in your humidifier:
Remove 1 vapor pad from the packaging, and insert it lengthwise into the vapor pad tray on the top of the exhaust grill. Vapor pads will typically last for 24 hours before needing replacement.
| Figure 3. |
Control | Niteglo™ |
Knob | Nitelight |
| O |
Vapor Pad Tray
| Figure 4. | 5 |
©2011 Hunter Fan Company |
| |
|
|
