2-1. Drill two pilot holes into the wood support structure through the outermost holes in the outlet box. e pilot holes should be 9/64” in diameter.
Note: Your fan comes with four pre-installed neoprene noise isolators.
2-2. read the lead wires from the outlet box down through the hole in the middle of the hanger bracket.
2-3. Align the slotted holes in the hanger bracket with the pilot holes you drilled in the wood support structure. For proper alignment use slotted holes directly across from each other. If you are installing the fan on an angled ceiling, be sure to orient the hanger bracket with the large opening towards the ceiling peak.
Note: e isolators should be flush against the ceiling.
2-4. Place a flat washer on each of the two 3” screws and pass the screws through the slotted holes in the hanger bracket into the pilot holes you drilled.
Tighten the screws into the 9/64” pilot holes; do not use lubricants on the screws. Do not over tighten.
Flat Washer
3” Screw
2 • Installing the Hanger Bracket
5
Steps 2-2 – 2-4
Step 2-3 (Angled Ceiling Only)
For Angled Ceilings: Be sure to orient the hanger bracket with the large opening towards the ceiling peak.
