Hunter Fan 42605-01 warranty Uninstalling the Light Fixture

7 • Completing Your Installation With or Without a Light Fixture (continued)

12

Uninstalling the Light Fixture
	Steps 1 – 6	Light
1. You must remove the wiring harness and its	Reversing	Assembly
		Housing
components from the integrated light fixture. You	Switch
must then install the wiring harness into the empty		Capacitors
switch housing included with the fan.
2. Locate the reversing switch and carefully remove the	Fan
two screws holding the reversing switch to the lower
	Speed	Light
switch housing. Now, remove the reversing switch
	Switch	Switch
from the housing.
3. Remove the patented breakaway connector from
the end of the fan pull chain. Carefully loosen the
bellmouth nut from the pull chain and remove the
pull chain switch from the light fixture housing.		Bellmouth Nuts

4.Locate and carefully remove the two capacitors.

5.In the light fixture housing there are the following plug connectors: one multi-wire connector and two two-wire connectors. Unplug the two-wire connectors; one connector will have a black with white striped wire and a white wire coming from the multi-wire connector.

6.You have now disconnected the wiring harness and its components and are ready to install them into the empty

	switch housing. (e light switch remains in the light	Steps 7 – 11
	assembly housing.)	Switch
7.	Insert the pull chain and fan pull chain switch through the
		Housing
	round opening on the side of the empty switch housing.
	read the bellmouth nut over the pull chain and hand
	tighten the bellmouth nut.
8.	Reattach the breakaway connector to the pull chain.	Fan
9.	Insert the reversing switch into the square hole on the side of	Speed
		Switch
	the switch housing. Install and tighten the two screws
	you removed previously from the other switch housing.

10.Carefully place the capacitors in the switch housing.

11.Continue with Step 7-6 on page 11.

Hunter Fan Company 42605-01 • 02/16/06