WARNING: Failure to complete the following steps could cause the fan to fall.
Note: It is recommended you use a magnetic tip screwdriver for the following steps.
5-1. Rotate the hanger ball so the tab in the canopy is secure in the hanger ball groove. Note: Your fan may have multiple tabs and grooves that must be aligned.
5-2. Swing the fan up to align the canopy screw holes with the mounting holes on the ceiling plate.
WARNING: e slots in the canopy must remain engaged while swinging the canopy for alignment.
5-3. Holding the canopy up with the screw holes aligned, partially install two canopy screws into the holes opposite the ceiling plate tabs.
5-4. Partially install a canopy screw between the slots in the canopy. When all the holes are properly aligned, securely tighten all three canopy screws.
5-5. Verify that the tabs in the canopy are still in the grooves of the hanger ball.
5-6. Align the tabs on the trim ring opposite the grooves in the hanger ball. Using both hands, push the canopy trim ring up to the top of the canopy. e canopy trim ring will snap and lock into place.
Note: Should you need to remove the trim ring, press firmly on opposite sides of the trim ring directly above the groove in the hanger ball. e tabs will flex out releasing the canopy trim ring.