Hunter Fan 42620-01 installation manual Fit together one way. Make sure the connectors are

7 • Completing Your Installation With or Without a Multi Staked Light Fixture (Cont.)

7-6. To attach the lower switch housing, connect the upper
plug connector from the motor to the lower plug
connector in the lower switch housing assembly.	Lower
Note: Both plug connectors are polarized and will only	Switch
fit together one way. Make sure the connectors are	Housing
properly aligned before connecting them. Incorrect	Shade
connection could cause improper operation and	Cup
damage to the product.

7-7.	Place the lower switch housing assembly over the upper		Shade
	switch housing. Align the side screw holes in the upper		Ring
	and lower switch housings. Attach the lower switch		Steps 7-6 – 7-7
	housing to the upper switch housing with three housing
	assembly screws.
7-8.	Remove the shade ring from each shade cup.
7-9.	Install each glass shade in a shade cup.
7-10. Install and tighten the shade ring to secure the glass
	shade. Do not overtighten.	Plug
7-11. install candelabra bulbs (60 Watt Maximum) into the		Connector	Housing
		Detail	Assembly Screw
	sockets.

Note: In compliance with U.S. Federal energy regulations, this
ceiling fan contains a wattage saver that restricts the light	Shade
kit to a maximum of 190 Watts. Exceeding that limit or
	Cup
the specifications on the light sockets may result in fire
hazard or improper operation. If lights do not appear to be
operating properly, see the troubleshooting section

Glass Shade

Shade Ring

Steps 7-9 – 7-10

11

42620-01 • 11/09/09 • Hunter Fan Company