WARNING: Failure to complete the following steps could cause the fan to fall.
Note: It is recommended you use a magnetic tip screwdriver for the following steps.
5-1. Rotate the hanger ball so the tab in the canopy is secure in the hanger ball groove. Note: Your fan may have multiple tabs and grooves that must be aligned.
5-2. Swing the fan up to align the canopy screw holes with the mounting holes on the ceiling plate.
WARNING: The slots in the canopy must remain engaged while swinging the canopy for alignment.
5-3. Holding the canopy up with the screw holes aligned, partially install two canopy screws into the holes opposite the ceiling plate tabs.
5-4. Partially install a canopy screw between the slots in the canopy. When all the holes are properly aligned, securely tighten all three canopy screws.
5-5. Verify that the tabs in the canopy are still in the grooves of the hanger ball.
5-6. Align the tabs on the trim ring opposite the grooves in the hanger ball. Using both hands, push the canopy trim ring up to the top of the canopy. The canopy trim ring will snap and lock into place.
Note: Should you need to remove the trim ring, press firmly on opposite sides of the trim ring directly above the groove in the hanger ball. The tabs will flex out releasing the canopy trim ring.
