Hunter Fan 42686-01 Setting the Remote Transmitter and Receiver, Setting Jumpers

4 • Setting the Remote Transmitter and Receiver

You must now set the jumpers in the remote transmitter and receiver so that they match.

Example Jumpers Settings

4-1. Change the position of the jumpers in the transmitter and the receiver. Be sure the position of the jumper in the transmitter matches the position of the jumper in the receiver. If they don’t match, the controller will not function. For instructions on how to set the jumpers, read the box below.

4-2. Install the included 12-volt battery into the transmitter.

Setting Jumpers

When two or more fans are located near each other, you may desire to have the receiver/transmitter for each fan set to a different code, so that the operation of one fan does not affect the operation of the other fans.

In the transmitter you can access the jumpers from the battery compartment. The jumpers are very small. You can move them most easily using a small pair of pliers or tweezers. IMPORTANT! Before you change a jumper, make sure the battery is not connected to the transmitter.

CAUTION: The remote control device complies with part 15 of the FCC rules. Changes or modifications not expressly approved by Hunter Fan Company could void your authority to operate this equipment.

Operation is subject to the following two conditions:

1.This device may not cause harmful interference.

2.This device must accept any interference received, including interference that may cause undesired operation.

Note: Use with a fan that incorporates an air gap switch (normal on-off wall switch).

WARNING: Maximum fan load is 1 Amp; maximum lamp is 100 Watts. Do not use any speed control with this product.

Receiver 1

4 3 2 1

Transmitter 1

4 3 2 1

4 = off (apagado)

3 = on (encendido)

2 = on (encendido)

1 = on (encendido)

Receiver 2

4 3 2 1

Transmitter 2

4 3 2 1

4 = off (apagado)

3 = on (encendido)

2 = off (apagado)

1 = on (encendido)

7

42686-01 • 01/07/09 • Hunter Fan Company